Hey! If you’ve just bought a lace front wig and you’re excited to start wearing it, but you’re not sure how to install it, don’t worry—you’re not alone. Installing and caring for a lace front wig can seem tricky at first, but with a bit of practice, you’ll get the hang of it. Today, I’m going to share with you a detailed, step-by-step guide to make sure your wig looks as natural and beautiful as possible. Plus, I’ll throw in some personal stories and tips to help you along the way. Let’s dive in!

Part 1: Prepping Your Hair and the Lace Front

Step 1: Thread the Needle

First, we need to get our supplies ready. Take a large C-shaped needle and thread it with cotton thread that matches your wig. This is super important because you don’t want the stitches to be visible. Pull the thread through the eye of the needle until you have a double strand about three feet long. Knot the end and cut the string below the knot.

Personal Tip: I remember the first time I did this, I didn’t match the thread color properly. The stitches stood out, and it wasn’t a good look. Matching the thread makes a huge difference.

Step 2: Braid Your Hair

Next, braid your hair into cornrows to ensure it lays flat under the wig. Part your hair into small sections, about half an inch wide. Start with a basic three-strand braid, and add a little more hair each time you cross the strands. Braid all the way to the end of your scalp and secure the ends by pulling them into a ponytail or sewing them down.

Why This Matters: If the braids are too big or chunky, your wig won’t sit flat. But don’t braid too tightly, as this can cause discomfort or even hair loss. I learned this the hard way when my scalp was sore for days!

Step 3: Cut the Lace Frontal

If you’re using a lace frontal, measure from ear to ear along your hairline and subtract an inch to account for the lace’s stretch. Use this measurement to cut the lace frontal to the correct length. For example, if your hairline measures 12 inches, cut the lace to 11 inches.

Pro Tip: Always double-check your measurements before cutting. Once, I cut a lace frontal too short, and it didn’t cover my hairline properly. Better safe than sorry!

Step 4: Use a Mesh or Stocking Cap

You might find that wearing a mesh or stocking cap helps reduce itching and keeps your wig in place. However, it’s fine to skip this step if you prefer. If you wear a cap, you can sew it down with a few stitches near your temples, crown, and the base of your neck.

Comfort Tip: I usually sew my cap down because it makes the wig feel more secure and reduces itching, which can be a real lifesaver during long days.

Part 2: Placing and Sewing the Lace Front

Step 1: Position the Wig

Place the wig on your head with the hairline exactly where you want it. Slide your fingers into the sides of the wig and pull it onto your scalp, aligning the hairline of the wig with your natural hairline. This step is crucial because once it’s sewn down, adjusting the wig is difficult.

Quick Story: The first time I installed my wig, I didn’t pay attention to the placement. It ended up too far back, and it looked really odd. Now, I always make sure it’s perfectly aligned before sewing.

Step 2: Stitch the Wig Near Your Ear

Hold the hairline of the wig in place and use your curved needle to make small, neat stitches along the braid closest to your ear. Push the needle through the lace and into the braid, following the natural curve of the needle. Continue stitching along the braid, knotting the thread behind your ear and cutting the excess thread.

Personal Experience: My first few attempts were messy, but with practice, I got better at making neat and secure stitches.

Step 3: Sew from Ear to Ear

If you’re using a full lace-front wig, part your hair from ear to ear and make 3-4 small stitches in each braid along this part. This helps secure the wig and keeps it from shifting.

Pro Tip: Hold the wig tightly while sewing to prevent it from sliding back. A secure wig is a confident wig!

Step 4: Stitch Above the Other Ear

Pull the lace-front down on the opposite side and stitch along the braid above your other ear. Make sure it’s tight enough to be secure but not uncomfortable. Knot the thread just behind your ear when you’re done.

Final Check: After sewing, I always wiggle the wig to ensure it’s secure. If it moves, I add more stitches.

Step 5: Add Extra Stitches if Needed

If the wig doesn’t feel secure, add a row of stitches from front to back. Part your hair where you wouldn’t normally part it and add stitches through each braid. This extra row provides additional security.

Extra Security: I’ve found that adding this row makes a huge difference in how stable the wig feels, especially during windy days!

Part 3: Finishing the Look

Step 1: Install Sew-In Tracks

If you’re wearing a frontal, you’ll need to add extensions or tracks to complete the look. Place a weft of hair along the base of your neck and sew it down to the braids. Continue sewing rows of tracks, spacing them about a quarter to half an inch apart, until you reach the back edge of the frontal.

Layering Tip: This method gives a thicker, more natural look than using a full wig. It’s my go-to for special occasions!

Step 2: Trim Any Visible Lace

After sewing the wig, trim any visible lace around your hairline with nail scissors. Be careful not to cut into the actual wig, only the excess lace.

Careful Cutting: I learned to take my time with this step. Rushing can lead to cutting too much and ruining the wig.

Step 3: Apply Glue Gel

To keep the lace flat against your forehead, apply glue gel along the hairline of the wig. Press the lace into the gel to secure it. This prevents the lace from lifting and gives a seamless look.

Favorite Product: I use Got2b glue gel, but any good quality glue gel will work. It’s a game-changer for keeping the wig in place.

Step 4: Use Edge Control for Baby Hairs

If you like the look of baby hairs, apply edge control to smooth down the fine hairs around your hairline. Use your fingertips to style the hairs naturally or create stylish swoops.

Styling Tip: Edge control gives a polished finish. It’s a small detail that makes a big difference in the overall look.

My Wig Journey: Personal Stories and Tips

When I first started wearing wigs, I was clueless about how to install and care for them. My initial attempts were messy, and my wigs didn’t last long. Over time, with practice and a lot of YouTube tutorials, I got better. Now, installing and styling my wig is like second nature. It’s not just about looking good; it’s about feeling confident and comfortable.

Emotional Connection

For me, wearing a wig is more than just a fashion statement. It boosts my confidence, especially on bad hair days or when I’m going through hair loss. Knowing how to properly install and care for my wig has made a huge difference in my self-esteem. I love experimenting with different styles and colors, and a well-installed wig makes all the difference.

Sharing the Knowledge

One of the best parts of learning these skills is sharing them with others. I’ve helped friends and family improve their wig techniques, and it’s amazing to see the positive impact it has on their confidence. It’s a small thing, but it can make such a big difference.

Conclusion

Installing and caring for a lace front wig might seem daunting at first, but with a little practice, you’ll become a pro. Remember to be patient, take your time, and follow these steps to ensure your wig looks natural and stays secure. Whether you’re getting ready for a special event or just want to switch up your look, a properly installed lace front wig can make you feel fabulous. So, go ahead, give it a try, and enjoy your beautiful, confident new look!